|
|
|
Gsk CNC Equipment Co.,Ltd.
|
|
| |
|
|
|
|
|
|
 Click to enlarge image
|
 Model Number |
GSK980TA |
Control function
Controlled axis:X,Z,
Min. command unit:0.001mm
Interpolation ways:X,Z axis linear, circular interpolation
Programming command range:+-9999.999mm
Max. rapid speed:7600mm/min 30000mm/min(adaptive)
Max. feed speed: linear speed 7600mm/min(electric gear ratio 1:1)
Feed per rev:0.001~500mm/Rev(must equipped with 1024 P/r spindle coder)
Feedrate override:0~150% 16 grades tune real time
Rapid override:25%,50%,75%,100%
Acceleration/deceleration mode:the linear rapid acceleration/ deceleration, the index feed acceleration/deceleration,the parameter can be tuned
electric gear ratio:1~127/1~127
Electronic handwheel function: with
Display windows
Monitor display type:320?240 lattice in blue(LCD),CCFL in a poor light
Display mode: Chinese(adaptive English menu)
Diagram display function: with
? function
23 kinds of G command, including 3 single fixed and 7 compound cycle commands, 8 user read/ write macro commands, max. 16 input/6 output points, double subprogram call, user macro program call
Thread function
Metric/Inch single straight thread, taper thread, metric/inch face thread. And the ending of thread can be set( set by the parameter)
Pitch:0.001~500.000mm(metric) 0.06~254000.000 tooth/inch ( Inch)
Spindle coder:1024p/r incremental coder
Compensation function
Backlash compensation:(X,Z axis)
Pitch error compensation:(X,Z axis)(adaptive)
Tool point radius compensation:(X,Z axis)(adaptive)
Tool compensation:16 groups tool length compensation
Tool function
Adaptive toolpost:max. setting 8 tool selections electric toolpost(can adapt 12 tool selections toolpost function, select the near toolpost without chuck/tailstock control function)
Tool selection signal input mode:directly input
Tool change mode:MDI/automatic absolute tool change or manual relative tool change, tool selection by forward rotation, clamp by backward rotation
Toolsetting mode: fixed point and trial cutting toolsetting
Tool compensation mode: move the tool/coordinate offset(set by parameter)
Spindle control
Control mode: 4-gear or analog control
Gear control:S1,S2,S3,S4 direct output
Analog control: set as 4-gear spindle auto or manual shifting, and output 0~10V control spindle speed
Constant linear cutting function: with( its function is valid when select the spindle analog control)
Auxiliary function
Control the spindle start/stop, reverse, stop; coolant On/Off; lubricate start/stop; chuck clamp/unclamp; tailstock feed/retract in Manual/MDI? control the spindle frequency conversion automatic shifting in MDI/Auto mode
Program edit
Program capacity:40KB,63 programs
Subprogram:can be edited
Communication
Standard RS232 communication interface?adaptive communication function and supplying for the communication software and cable, transmitting the program with PC each other
|
|
|
|
| |
|
|
|
Related Keywords:
Bookmark / Share this page